• - 交流-直流(AC-DC)控制器和稳压器
• - 直流-直流(DC-DC)控制器、转换器和稳压器
• - 电压和电流管理
• - 通讯IC
• - 驱动器
• - 热管理

• - 时钟及数据分配
• - 标准逻辑

• - 放大器和比较器
• - 模拟开关
• - 数字电位计
• - 接口
• - EMI和RFI滤波器

• - EEPROM存储器
• - 非易失性只读存储器(NVRAM)
• - SRAM存储器

说明

The TUSB1310A is a single port, 5.0-Gbps USB 3.0 physical layer transceiver operating off of a single reference clock provided by either a crystal or an external reference clock. The reference clock frequencies are selectable from 20, 25, 30, and 40 MHz. The TUSB1310A provides the clock to the USB controller. The use of a single reference clock allows the TUSB1310A to provide a cost effective USB 3.0 solution with few external components and a low implementation cost.

The USB controller interfaces to the TUSB1310A via a PIPE (SuperSpeed) and a ULPI (USB2.0) interface. The 16-bit PIPE operates off of a 250-MHz interface clock. The ULPI supports 8-bit operations with a 60-MHz interface clock.

USB 3.

特性

• Universal Serial Bus (USB)
  • Single Port 5.0-Gbps USB 3.0 Physical Layer Transceiver
    • One 5.0-Gbps SuperSpeed Connection
    • One 480-Mbps HS/FS/LS Connection
  • Fully Compliant with USB 3.0 Specification, Revision 1.0
  • Supports 3+ Meters USB 3.0 Cable Length
  • Fully Adaptive Equalizer to Optimize Receiver Sensitivity
  • PIPE to Link Layer Controller
    • Supports 16-Bit SDR Mode at 250 MHz
    • Compliant With PHY Interface for the USB Architectures (PIPE), Version 3.0
  • ULPI to Link Layer Controller
    • Supports 8-Bit SDR Mode at 60 MHz
    • Supports Synchronous Mode and Low Power Mode
    • Compliant with UTMI+ Low Pin Interface (ULPI) Specification, Revision 1.1
• General Features
  • IEEE 1149.1 JTAG Support
  • IEEE 1149.6 JTAG support for the SuperSpeed Port
  • Operates on a Single Reference Clock of 40 MHz
  • 3.3-, 1.8-, and 1.1-V Supply Voltages
  • 1.8-V PIPE and ULPI I/O