品牌索引 产品分类 > 小信号开关二极管> 瞬态电压抑制器TVS/ESD> 双极管二极管> 调谐二极管> 齐纳(稳压)二极管> 小信号肖特基二极管> 频带转换二极管> 中/高功率管> 射频PIN二极管> Sinterglass二极管> 整流器 > N沟道(N-Channel)> P沟道(P-Channel)> 双N沟道(Dual N-Channel)> 双P沟道(Dual P-Channel)> 双N和P沟道(Dual N and P-Channel)
|
产品介绍
特性
(1)Component qualification in accordance with JEDEC and industry standards to ensure reliable operation over an extended temperature range. This includes, but is not limited to, Highly Accelerated Stress Test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold-compound life. Such qualification testing should not be viewed as justifying use of this component beyond specified performance and environmental limits. Widebus, EPIC-IIB are trademarks of Texas Instruments. DESCRIPTION/ORDERING INFORMATIONThe SN74ABT16373A-EP is a 16-bit transparent D-type latch with 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. The SN74ABT16373A-EP is particularly suitable for implementing buffer registers, I/O ports, bidirectional bus drivers, and working registers. The SN74ABT16373A-EP can be used as two 8-bit latches or one 16-bit latch. When the latch-enable (LE) input is high, the Q outputs follow the data (D) inputs. When LE is taken low, the Q outputs are latched at the levels set up at the D inputs. A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or low logic levels) or a high-impedance state. In the high-impedance state, the outputs neither load nor drive the bus lines significantly. The high-impedance state and the increased drive provide the capability to drive bus lines without need for interface or pullup components. OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while the outputs are in the high-impedance state. When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver. The SN74ABT16373A-EP is characterized for operation from -55°C to 125°C. |