BU7807-01 Features:
• Optimized for Welding, UPS and SMPS Applications • Operating Frequencies > 20 kHz Hard Switching, >200 kHz Resonant Mode • Low EMI, requires Less Snubbing • Direct Mounting to Heatsink • PCB Solderable Terminals • Very Low Junction-to-Case Thermal Resistance
BU7807-01(Absolute) Maximum Ratings:
High-power capability PowerSO-36; V cc /2 compatible inputs; Junction over-temperature protection; Case over-temperature protection for thermal independence of the channel; Current limitation; Shorted load protection; Under-voltage shutdown; Protection against loss of ground; Very low stand-by current; Compliance with 6100-4-4 IEC test up to 4.4kV.
BU7807-01 Pinout:
A Read Data from Memory (READ) instruction loads the address of the first byte or word to be read in an internal address register. The data at this address is then clocked out serially. The ad- dress register is automatically incremented after the data is output and, if Chip Select Input (S) is held High, the M93Cx6 can output a sequential stream of data bytes or words. In this way, the memory can be read as a data stream from eight to 16384 bits long (in the case of the M93C86), or continuously (the address counter automatically rolls over to 00h when the highest address is reached). Programming is internally self-timed (the external clock signal on Serial Clock (C) may be stopped or left running after the start of a Write cycle) and does not require an Erase cycle prior to the Write instruction. The Write instruction writes 8 or 16 bits at a time into one of the byte or word locations of the M93Cx6. After the start of the programming cy- cle, a Busy/Ready signal is available on Serial Data Output (Q) when Chip Select Input (S) is driv- en High.
