品牌索引 产品分类 > 小信号开关二极管> 瞬态电压抑制器TVS/ESD> 双极管二极管> 调谐二极管> 齐纳(稳压)二极管> 小信号肖特基二极管> 频带转换二极管> 中/高功率管> 射频PIN二极管> Sinterglass二极管> 整流器 > N沟道(N-Channel)> P沟道(P-Channel)> 双N沟道(Dual N-Channel)> 双P沟道(Dual P-Channel)> 双N和P沟道(Dual N and P-Channel)
|
首 页 > 新闻动态 > 公司新闻 > 供应 TPS2065DGNR-1 TI TSSOP8单1A电流限制,配电开关为USB应用 供应 TPS2065DGNR-1 TI TSSOP8单1A电流限制,配电开关为USB应用The TPS206x power-distribution switches are intended for applications where heavy capacitive loads and short-circuits are likely to be encountered. This device incorporates 70-m N-channel MOSFET power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by a logic enable input. Gate drive is provided by an internal charge pump designed to control the power-switch rise times and fall times to minimize current surges during switching. The charge pump requires no external components and allows operation from supplies as low as 2.7 V.When the output load exceeds the current-limit threshold or a short is present, the device limits the output current to a safe level by switching into a constant-current mode, pulling the overcurrent (OCx) logic output low. When continuous heavy overloads and short-circuits increase the power dissipation in the switch, causing the junction temperature to rise, a thermal protection circuit shuts off the switch to prevent damage. Recovery from a thermal shutdown is automatic once the device has cooled sufficiently. Internal circuitry ensures that the switch remains off until valid input voltage is present. This power-distribution switch is designed to set current limit at 1.5 A typically. |


























































































N-channel MOSFET power switches for power-distribution systems that require multiple power switches in a single package. Each switch is controlled by a logic enable input. Gate drive is provided by an internal charge pump designed to control the power-switch rise times and fall times to minimize current surges during switching. The charge pump requires no external components and allows operation from supplies as low as 2.7 V.