• - 交流-直流(AC-DC)控制器和稳压器
• - 直流-直流(DC-DC)控制器、转换器和稳压器
• - 电压和电流管理
• - 通讯IC
• - 驱动器
• - 热管理

• - 时钟及数据分配
• - 标准逻辑

• - 放大器和比较器
• - 模拟开关
• - 数字电位计
• - 接口
• - EMI和RFI滤波器

• - EEPROM存储器
• - 非易失性只读存储器(NVRAM)
• - SRAM存储器

说明

The ISO3080, and ISO3086 are isolated full-duplex differential line drivers and receivers while the ISO3082, and ISO3088 are isolated half-duplex differential line transceivers for TIA/EIA 485/422 applications.

These devices are ideal for long transmission lines since the ground loop is broken to allow for a much larger common-mode voltage range. The symmetrical isolation barrier of the device is tested to provide 2500 Vrms of isolation for 60s between the bus-line transceiver and the logic-level interface.

Any cabled I/O can be subjected to electrical noise transients from various sources. These noise transients can cause damage to the transceiver and/or near-by sensitive circuitry if they are of sufficient magnitude and duration.

特性

• 4000-V_PEAK Isolation, 560-V_peak V_IORM
  • UL 1577, IEC 60747-5-2 (VDE 0884, Rev. 2),
    IEC 61010-1, IEC 60950-1 and CSA Approved
• Bus-Pin ESD Protection
  • 16 kV HBM Between Bus Pins and GND2
  • 6 kV HBM Between Bus Pins and GND1
• 1/8 Unit Load – Up to 256 Nodes on a Bus
• Meets or Exceeds TIA/EIA RS-485 Requirements
• Signaling Rates up to 20 Mbps
• Thermal Shutdown Protection
• Low Bus Capacitance – 16 pF (Typ)
• 50 kV/µs Typical Transient Immunity
• Fail-safe Receiver for Bus Open, Short, Idle
• 3.3-V Inputs are 5-V Tolerant
• APPLICATIONS
  • Security Systems
  • Chemical Production
  • Factory Automation
  • Motor/Motion Control
  • HVAC and Building Automation Networks
  • Networked Security Stations