• - 交流-直流(AC-DC)控制器和稳压器
• - 直流-直流(DC-DC)控制器、转换器和稳压器
• - 电压和电流管理
• - 通讯IC
• - 驱动器
• - 热管理

• - 时钟及数据分配
• - 标准逻辑

• - 放大器和比较器
• - 模拟开关
• - 数字电位计
• - 接口
• - EMI和RFI滤波器

• - EEPROM存储器
• - 非易失性只读存储器(NVRAM)
• - SRAM存储器

说明

The DRV8412/32 are high performance, integrated dual full bridge motor drivers with an advanced protection system.

Because of the low R_DS(on) of the H-Bridge MOSFETs and intelligent gate drive design, the efficiency of these motor drivers can be up to 97%, which enables the use of smaller power supplies and heatsinks, and are good candidates for energy efficient applications.

The DRV8412/32 require two power supplies, one at 12 V for GVDD and VDD, and another up to 50 V for PVDD. The DRV8412/32 can operate at up to 500-kHz switching frequency while still maintain precise control and high efficiency. They also have an innovative protection system safeguarding the device against a wide range of fault conditions that could damage the system.

特性

• High-Efficiency Power Stage (up to 97%) with
  Low R_DS(on) MOSFETs (80 m at T_J = 25°C)
• Operating Supply Voltage up to 50 V (70 V Absolute Maximum)
• DRV8412 (power pad down): up to 2 × 3 A Continuous
  Output Current (2 × 6 A Peak) in Dual Full Bridge Mode or
  6 A Continuous Current in Parallel Mode (12 A Peak)
• DRV8432 (power pad up): up to 2 × 7 A Continuous Output
  Current ( 2 × 12 A Peak) in Dual Full Bridge Mode or 14 A
  Continuous Current in Parallel Mode (24 A Peak)
• PWM Operating Frequency up to 500 kHz
• Integrated Self-Protection Circuits Including Undervoltage,
  Overtemperature, Overload, and Short Circuit
• Programmable Cycle-by-Cycle Current Limit Protection
• Independent Supply and Ground Pins for Each Half Bridge
• Intelligent Gate Drive and Cross Conduction Prevention
• No External Snubber or Schottky Diode is Required
• APPLICATIONS
  • Brushed DC and Stepper Motors
  • Three Phase Permanent Magnet Synchronous Motors
  • Robotic and Haptic Control System
  • Actuators and Pumps
  • Precision Instruments
  • TEC Drivers